1 BERCO Subframe for JOHN DEERE 300 SERIES Tractors CAUTION: READ & FOLLOW ALL SAFETY RULES & INSTRUCTIONS BEFORE OPERATING YOUR EQUIPME
8 ASSEMBLY Remove the belt guard from the back of snowblower. Remove the hair pin (item 6). Release the tension on the belt by moving the tension arm
9 Insert the handle (item 1) into the support (item 2) as shown. Install the hook (item 3) on the rotation worm (item 4). Insert the hook in the ha
10 ASSEMBLY ASSEMBLY NOTE: In order to install the Rotary Broom on this subframe, the V-idler pulley kit (700252) is required. Replace the flat idl
11 ASSEMBLY Remove the hair pin (item 6). Release the tension on the belt by moving the idler arm (item 7) forward. Install the V-belt by threading it
12 MAINTENANCE ASSEMBLY VERIFY TIRE PRESSURE: Check and adjust tractor tire pressure as follows: Front tires: 20-25 psi Back tires: 8-10
13 ASSEMBLY UTILITY BLADE INSTALLATION: Refer to Utility Blade owner’s manual, parts breakdown section for parts identification. WARNING FOR YOUR SE
14 MAINTENANCE & DISMOUNTING WARNING TO PREVENT INJURIES: Stop the motor. Apply parking brakes. Remove the ignition key. Disconnect the wire f
15 TORQUE SPECIFICATION TABLE GENERAL TORQUE SPECIFICATION TABLEUSE THE FOLLOWING TORQUES WHEN SPECIAL TORQUES ARE NOT GIVEN NOTE: These values a
16 PARTS BREAKDOWN SUBFRAME
17 O/L = Obtain Locally PARTS LIST SUBFRAME Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 1 Pivot support Support
2 LIMITED WARRANTY Bercomac Limitée 92, Fortin North, Adstock, Quebec, Canada, G0N 1S0 Conditions and Products Covered: BERCOMAC guarantees any par
18 PARTS LIST SUBFRAME Ref. Réf. English description Description française Qty. Qté. Part # Pièce # 28 Flat pulley Poulie plate 1 102300 29 &q
19 ATTACHMENTS ROTARY BROOM /#700316 with polypropylene brush. Fits on same subframe as snowblower & utility blade. Requires an adaptor. UTILIT
20 NOTES ____________________________________________________________________________________________________________________________________________
21 NOTES ____________________________________________________________________________________________________________________________________________
22 WHEN PERFORMANCE & DEPENDABILITY ARE NON NEGOTIABLE ! Bercomac Limitée 92, Fortin North, Adstock, Quebec, Canada, G
1 TABLE OF CONTENTS INTRODUCTION ...
2 INTRODUCTION TO THE PURCHASER This new accessory was carefully designed to give years of dependable service. This manual has been provided to ass
3 SAFETY PRECAUTIONS Careful operation is your best insurance against an accident. Read this section carefully before operating the vehicle and acces
4 OPERATION: 1. Do not put hands or feet near, under or inside rotating parts. 2. Exercise extreme caution when operating on or crossing gravel
5 ASSEMBLY IMPORTANT: TORQUE ALL BOLTS ACCORDING TO TORQUE SPECIFICATION TABLE (SEE TABLE OF CONTENTS) WHEN STATED: TIGHTEN FIRMLY. REFER TO PARTS BRE
6 ASSEMBLY Adjust the overall length of the push tube (item 1) to 37 3/4" by screwing or unscrewing the adjusting rod (item 2). Place the end of
7 ASSEMBLY Install the snowblower to the subframe as shown. Make sure the snowblower is pushed in until locked into place by the springs (item 1).
Comments to this Manuals