Bercomac 700416 Owner's Manual download pdf (Page 8)

ASSEMBLY

Install the hand guard (item 1) in the chute (item 2) as

shown.

Secure in place with two 1/4 x 3/4" hex bolts, two flat

washers and two 1/4’’ flange nuts on the inside.

Tighten firmly.

Install chute

Install hand guard

Before installing the chute (item 1), loosen the two

flange nuts (item 2) (down to the last threads) which

holds the rotation system (item 3).

Install the rotation ring (item 4) over opening (item 5)

as shown and align the notches.

Place the chute (item 1) (facing the rear) and clip the

back over the rotation ring then turn the chute

towards the front to lock into place.

Reinstall the rotation system by tightening the flange

nuts firmly.

STEP 1

CHUTE INSTALLATION:

Refer to parts breakdown section for parts identification.

IMPORTANT: TORQUE ALL BOLTS ACCORDING TO

TORQUE SPECIFICATION TABLE (SEE TABLE OF

CONTENTS), WHEN STATED: TIGHTEN FIRMLY.

TOOL REQUIRED:

Ratchet

Sockets: 7/16’’, 1/2’’

Wrench: 7/16’’

Hexagonal wrench: 3/16’’

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

Bercomac 700416 Owner's Manual Page 8