Bercomac Berco 700255-1 Owner's Manual download pdf (Page 17)

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSES CORRECTIVE ACTION

Nylon shear pin is probably broken. Replace shear pin (for identification,

see parts list "Snowblower").

The reduction chain is broken or the

connecting link is unlocked.

Remove both chain guards. Inspect

& repair chain if needed (for

identification, see parts list

"Snowblower").

Fan stops turning. Shear bolt is probably broken. Replace shear bolt (for

identification, see parts list

"Snowblower").

Snowblower stops turning. One of the two belts is probably

damaged or broken.

Check both belts and replace

damaged belt(s) (for instructions,

see Belt Replacement section).

Belt has burn marks in specific

places.

Lack of tension on belt.

Snowblower engaged when

plugged.

Adjust manual clutch cable or

replace springs if stretched.

Make sure the auger & the fan are

not frozen or plugged before

engaging.

Chute plugs easily. Tractor engine turning too slowly.

Advancing too quickly with tractor.

Run engine at full throttle during

snowblowing operation.

Allow snowblower to ingest snow at

its own speed.

Chute rotation is difficult. Dirt or ice may be underneath

chute.

Dismount chute by removing the

rotation worm (for identification, see

parts list "Chute with Rotation

System"). Turn the chute

completely towards the rear and it

will disconnect from base. Clean the

base of chute and the rotation ring.

Lubricate & re-install.

Auger stops turning.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comments to this Manuals

No comments

Bercomac Berco 700255-1 Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Snow throwers Bercomac Berco 700255-1